R&S RTO6 - Page 88

Instrument setup
R&S
®
RTO6
88User Manual 1801.6687.02 ─ 05
Show labels
Switches the display of the mask test name on or off.
To change the name of the mask test, open the "Mask Test" dialog > "Define Mask"
tab. Double-tap the mask test subtab and enter the new mask test name.
Remote command:
MTESt:LABel on page 1317
MTESt:REName on page 1317
Show hits
If selected, the mask hits are highlighted on the screen. You can define the color and
the time of the hit display.
These settings are not applied to trigger zones, which are based on masks.
Remote command:
MTESt:HIGHlight:STATe on page 1317
Show for
Sets the time for which the mask hits are shown.
Remote command:
MTESt:HIGHlight:TIME on page 1317
Show hits forever
If selected, the mask hits are shown for an unlimited period of time.
Remote command:
MTESt:HIGHlight:INFinite on page 1317
Appearance settings