Protocol analysis
R&S
®
RTO6
970User Manual 1801.6687.02 ─ 05
SEARch:TRIGger:DDR:FRAMe<m>:FLD<n>:DMIN on page 2395
SEARch:
TRIGger:DDR:
DOPerator on page 2396
SEARch:TRIGger:DDR:FRAMe<m>:FLD<n>:DOPerator on page 2396
Index ← Set details
The search index setup consists of a comparison condition and one or two address
patterns.
"Condition"
Sets the comparison condition to a specific value or a range.
"Min"
Specifies the value or sets the start value of a range.
"Max"
Sets the maximum value of a range for "Condition" = "In range"/"Out
of range".
Remote command:
SEARch:TRIGger:DDR:
IMAX on page 2397
SEARch:TRIGger:DDR:FRAMe<m>:FLD<n>:IMAX on page 2397
SEARch:TRIGger:DDR:IMIN on page 2397
SEARch:TRIGger:DDR:FRAMe<m>:FLD<n>:IMIN on page 2397
SEARch:TRIGger:DDR:IOPerator on page 2397
SEARch:TRIGger:DDR:FRAMe<m>:FLD<n>:IOPerator on page 2397
13.27.2.2 DDR search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 420
●
Chapter 11.4.2, "Display zoom settings", on page 440
The results of the search are the same as for decoding, see Chapter 13.27.3, "DDR
decode results", on page 971.
Remote commands:
●
SEARch:RESult:DDR:FCOunt? on page 2398
●
SEARch:RESult:DDR:FRAMe<m>:FLD<n>:FVAL? on page 2398
●
SEARch:RESult:DDR:FRAMe<m>:FLD<n>:STARt? on page 2399
●
SEARch:RESult:DDR:FRAMe<m>:FLD<n>:STATus? on page 2399
●
SEARch:RESult:DDR:FRAMe<m>:FLD<n>:STOP? on page 2400
●
SEARch:RESult:DDR:FRAMe<m>:FLD<n>:VAL? on page 2400
●
SEARch:RESult:DDR:FRAMe<m>:NWRDs? on page 2400
●
SEARch:RESult:DDR:FRAMe<m>:STARt? on page 2401
●
SEARch:RESult:DDR:FRAMe<m>:STATe? on page 2401
●
SEARch:RESult:DDR:FRAMe<m>:STOP? on page 2401
DDR (option R&S R
T
O6-K91 )
To Next Page
Loading...
