Remote control commands
R&S
®
RTO6
1298User Manual 1801.6687.02 ─ 05
Suffix:
<m>
.
1...218
W
aveform number
, see Chapter 24.4.1, "Waveform suffix",
on page 1279.
Parameters:
<ColorTable> Color table name to be assigned to the signal.
DISPlay:COLor:SIGNal<m>:USE <State>
If enabled, the selected waveform is displayed according to its assigned color table.
If this option is disabled, the default color table is used, i.e. the intensity of the specific
signal color varies according to the cumulative occurance of the values.
Suffix:
<m>
.
1...218
W
aveform number
, see Chapter 24.4.1, "Waveform suffix",
on page 1279.
Parameters:
<State> ON | OFF
24.7.2.2 Color tables
DISPlay:COLor:PALette:ADD
........................................................................................ 1298
DISPlay:COLor:PALette:REMove...................................................................................1298
DISPlay:COLor:PALette:COUNt?...................................................................................1299
DISPlay:COLor:PALette:POINt:ADD.............................................................................. 1299
DISPlay:COLor:PALette:POINt:INSert............................................................................ 1299
DISPlay:COLor:PALette:POINt:REMove.........................................................................1299
DISPlay:COLor:PALette:POINt[:VALue]..........................................................................1299
DISPlay:COLor:PALette:POINt:COUNt?......................................................................... 1300
DISPlay:COLor:PALette:ADD <Name>
Adds a new color table with the specified name.
Setting parameters:
<Name> color table
Usage: Setting only
DISPlay:COLor:PALette:REMove <Name>
Removes the specified color table.
Setting parameters:
<Name> color table
Usage: Setting only
Instrument setup
To Next Page
Loading...
