R&S RTO6 - 24.23.15 Transient response

Remote control commands
R&S
®
RTO6
2554User Manual 1801.6687.02 ─ 05
Query parameters:
<VoltageMeasType> VOLTage | CURRent
*RST: VOLTage
Return values:
<Result> Statistic result
Usage: Query only
POWer:RIPPle:RESult:STDDev[:ACTual]? [<VoltageMeasT
ype>]
POWer:RIPPle:RESult:STDDev:AVG? [<VoltageMeasType>]
POWer:RIPPle:RESult:STDDev:EVTCount? [<VoltageMeasType>]
POWer:RIPPle:RESult:STDDev:NPEak? [<VoltageMeasType>]
POWer:RIPPle:RESult:STDDev:PPEak? [<VoltageMeasType>]
POWer:RIPPle:RESult:STDDev:RMS? [<VoltageMeasType>]
POWer:RIPPle:RESult:STDDev:STDDev? [<VoltageMeasType>]
POWer:RIPPle:RESult:STDDev:WFMCount? [<VoltageMeasType>]
Return the specified statistic result for the standard deviation of the long-term mea-
surement results.
●
[:ACTual]: current measurement result
●
AVG: average of the long-term measurement results
●
EVTCount: number of measurement results in the long-term measurement
●
NPEak: negative peak value of the long-term measurement results
●
PPEak: positive peak value of the long-term measurement results
●
RMS: RMS value of the long-term measurement results
●
STDDev: standard deviation of the long-term measurement results
Query parameters:
<VoltageMeasType> VOLTage | CURRent
*RST: VOLTage
Return values:
<Result> Statistic result
Usage: Query only
24.23.15 Transient response
This measurement is a single shot measurement. To start the measurement, use the
RUNS command.
Progragramming example: Chapter 24.3.8.2, "Transient response measurement",
on page 1278
POWer:TRANsient:AUToscale.......................................................................................2555
POWer:TRANsient:EXECute.........................................................................................2555
POWer:TRANsient:FREQuency.....................................................................................2555
POWer:TRANsient:HYSTeresis..................................................................................... 2555
POWer:TRANsient:INPut.............................................................................................. 2555
Power analysis (option R&S R
T
O6-K31)