Measurements
R&S
®
RTO6
297User Manual 1801.6687.02 ─ 05
8.2.1 Measurement setup in general
Up to 8 measurement groups can be defined. Each measurement group is configured
in its own subtab. For each measurement group, the category and the source are
defined in the "Setup"
tab, and you can also enable statistic evaluation. Available sour-
ces and measurements depend on the selected category, for example, histogram mea-
surements need a defined histogram as source. For each measurement group, you
select all required measurements. If further settings are available for a measurement, a
settings icon is shown beside the measurement's name.
8.2.1.1 Starting an automatic measurement
There are three methods to start an automatic measurement, each with slightly differ-
ent ef
fects:
●
Using the "Measure"
icon on the toolbar:
See: "To start a measurement using the toolbar icon" on page 297.
●
Using the "Measure" menu.
Pressing the [Measure] key on the front panel, or using the "Measure" menu.
See: Chapter 8.2.1.2, "Configuring measurements", on page 297.
To start a measurement using the toolbar icon
1. Tap the "Measurement" icon on the toolbar.
2. On the toolbar assist, select the category, the measurements and the source to be
measured.
3. Define the measurement range in one of these ways:
● T
o measure the complete waveform, tap the diagram with the waveform.
● To define a gate that limits the measurement, draw a rectangle on the screen.
The "Meas Results" are displayed.
8.2.1.2 Configuring measurements
1. Press the [Measure] key on the front panel, or open the menu and select "Mea-
sure".
The "Measurements" dialog box opens.
If you double-tap the title if a result table, the toolbar assist opens. Here you can
change the measurement types and enable statistics. If you tap "Advanced Setup"
,
the "Measurements" dialog box opens.
2. Select the subtab for the measurement group that you want to configure.
Automatic measurements
To Next Page
Loading...
