Spectrum analysis
R&S
®
RTO6
392User Manual 1801.6687.02 ─ 05
A small arrow icon labeled "T1" / "T2" indicates the position of the time line in the
spectrogram.
The spectrum diagram displays the results for the selected waveforms. A new sig-
nal icon is displayed on the signal bar for each time line (
"SGxTL1|2").
4.
To view the spectrum for each time line in a separate diagram, drag the signal icon
for one time line to the diagram area and drop it.
A new window is displayed for the selected time line, and the original diagram dis-
plays the other time line.
5. To view a different waveform from the spectrogram, move the time lines in the
spectrogram.
9.2.4 Spectrogram configuration settings
Access: [FFT] > "FFT setup" > "Spectogram" tab
Spectrograms are only available if the option R&S RTO6-K37 is activated. Further-
more, a math (FFT) waveform must be configured and enabled.
See Chapter 9.1.2, "Configuring spectrum waveforms", on page 374.
Display........................................................................................................................ 393
T
ime line 1/2................................................................................................................393
Show lines permanently..............................................................................................393
Spectrum analysis (option R&S RTO6-K37)
To Next Page
Loading...
