Network operation and remote control
R&S
®
RTO6
1243User Manual 1801.6687.02 ─ 05
Address
Indicates the GPIB address of the instrument if an optional GPIB bus card is installed.
The remote control address is factory-set to 20, but it can be changed if it does not fit
in the network environment. For remote control, addresses 0 through 30 are allowed.
The GPIB address is maintained after a reset of the instrument settings. Be aware that
changing the address has major ef
fects on the communication to the remote computer
.
Remote command:
GPIB:ADDRess on page 1294
Terminator
Specifies the symbol that is used as a terminator in GPIB communication.
Remote command:
GPIB:TERMinator on page 1295
22.5.2.2 Remote settings
Access: "Menu" > "Settings" > "System" > "Remote"
The following settings are required for remote control of the instrument via a connected
computer.
T
ransfer data format
Selects the data format that is used for transmission of waveform data from the instru-
ment to the controlling computer.
Waveform data can be retrieved using the following commands:
●
CHANnel<m>[:WAVeform<n>]:DATA[:VALues]?
●
CALCulate:MATH<m>:DATA[:VALues]?
●
REFCurve<m>:DATA[:VALues]?
●
DIGital<m>:DATA[:VALues]?
The content of the data stream can be defined with "Menu" > "Save/Recall" > "Save >
Waveforms > Interleaved X/Y" (or EXPort:WAVeform:INCXvalues).
"Ascii"
Data values are returned in ASCII format as a list of comma separa-
ted values in floating point format.
Remote control
To Next Page
Loading...
