R&S RTO6 - Page 1295

Remote control commands
R&S
®
RTO6
1295User Manual 1801.6687.02 ─ 05
GPIB:TERMinator <T
erminator>
Specifies the symbol that is used as a terminator in GPIB communication.
Parameters:
<T
erminator> LFEoi | EOI
*RST: EOI
Usage: Asynchronous command
SYSTem:DISPlay:MESSage:STATe <DispMessState>
Enables and disables the display of an additonal text in remote control.
To define the text, use
SYSTem:DISPlay:MESSage[:TEXT].
Parameters:
<DispMessState> ON | OFF
*RST: OFF
Usage: Asynchronous command
Firmware/software: Version 2.70
SYSTem:DISPlay:MESSage[:TEXT] <DisplayMessage>
Defines an additional text that is displayed during remote control operation.
To enable the text display
, use SYSTem:DISPlay:MESSage:STATe on page 1295.
Parameters:
<DisplayMessage> String that contains the text.
Usage: Asynchronous command
Firmware/software: Version 2.70
SYSTem:LANGuage <Language>
Defines the remote control behavior of the instrument and sets the remote control com-
mand set.
Parameters:
<Language> String value. Available values:
'SCPI': R&S R
T
O6 remote command set is used.
"DPO7000" or 'TDS540': Compatible remote command set of
Tektronix oscilloscopes DPO7000 or TDS540 is used.
If one of these emulation modes is used, you can define alterna-
tive responses to the IDN*? and OPT*? commands on the
"Menu" > "Settings" > "System" > "Remote" > "SCPI Emulation"
tab.
Usage: Asynchronous command
General remote settings