R&S RTO6 - 13.9.1.2 Display settings; 13.9.1.3 Configuring FlexRay protocol

Protocol analysis
R&S
®
RTO6
622User Manual 1801.6687.02 ─ 05
13.9.1.2 Display settings
Access: [Bus] >
"Display"
tab.
For common display settings, see Chapter 13.1.3, "Display", on page 487.
FlexRay Specific Label Settings
Label lists are protocol-specific. A FlexRay label file contains four values for each iden-
tifier:
●
"ID / Addr": number of the slot in which the frame is transmitted
●
"Base cycle" and "Repetition": define the cycle indexes for which the identifier
applies. Base cycle defines the first applied cycle.
There are 64 cycles in a FlexRay communication. The same identifier can be
shared by different devices, and each device uses the identifier at different cycles.
For example:
0x0AB,0,2,Ignition_Info: uses cycles 0,2,4,6,...,62
0x0AB,1,2,GearBoxInfo: uses cycles 1,3,5,7,...,63
●
"Symbolic label": symbolic name of the identifier, specifying the device function.
Example: FlexRay PTT file
# ----------------------------------------------------------------------------
@FILE_VERSION = 1.0
@PROTOCOL_NAME = flexray
# ----------------------------------------------------------------------------
# Labels for FlexRay protocol
# Column order: Identifier, Base cycle, Cycle repetition, Label
# ----------------------------------------------------------------------------
# ----Definition----
0x01D,0,2,DriveTrain
0x03D,3,3,EngineData
0x0AB,0,2,Ignition_Info
0x0AB,1,2,GearBoxInfo
0x1C4,1,2,ABSdata
0x1F5,0,1,BrakeControl
0x200,0,1,Engine_Status
0x2BA,0,1,Airbag_Status
0x2D9,0,1,TP_Console
0x340,0,2,CAN_Gateway
0x38B,55,1,MOST_Gateway
0x3EA,0,1,PressureInfo
# ----------------------------------------------------------------------------
13.9.1.3 Configuring FlexRay protocol
The configuration of the FlexRay is simple - assign the two lines to input channels, and
set the thresholds.
For details on configuration settings, see Chapter 13.9.1.1, "FlexRay configuration",
on page
618.
FlexRay (option R&S
RT
O6-K520)