R&S RTO6 - 24.17.22 USB 3.1 (option R&S RTO6-K570); 24.17.22.1 Configuration

Remote control commands
R&S
®
RTO6
2188User Manual 1801.6687.02 ─ 05
24.17.22 USB 3.1 (option R&S RT
O6-K570)
● Configuration.......................................................................................................2188
● Digital signal processing (DSP)...........................................................................2190
● T
rigger.................................................................................................................2193
● Decode results.................................................................................................... 2204
● Search settings................................................................................................... 2208
● Search results..................................................................................................... 2214
24.17.22.1 Configuration
In all BUS<m>:USBT commands, the suffix <m> selects the serial bus.
BUS<m>:USBThree:SOURce....................................................................................... 2188
BUS<m>:USBThree:POLarity........................................................................................2188
BUS<m>:USBThree:THRHigh.......................................................................................2189
BUS<m>:USBThree:THRLow........................................................................................2189
BUS<m>:USBThree:SCRMode..................................................................................... 2189
BUS<m>:USBThree:TYPE............................................................................................2189
BUS<m>:USBThree:SOURce <SourceData>
Selects the source for the data signal in the USB 3.1 protocol.
Suffix:
<m>
.
1..4
Parameters:
<SourceData> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 |
R1 | R2 | R3 |
R4
*RST: C1W1
Usage: Asynchronous command
BUS<m>:USBThree:POLarity <Polarity>
Defines the polarity of the data signal for the active (U0) state of the port.
Suffix:
<m>
.
1..4
Parameters:
<Polarity> NORMal | INVert
NORMal
Normal (non-inverted) data signal polarity
INV
ert
Inverted data signal polarity
*RST
: NORMal
Protocols