Measurements
R&S
®
RTO6
293User Manual 1801.6687.02 ─ 05
X1 label, X2 label
Defines a label to be displayed with the vertical cursors.
By default, the cursors are labeled as Cu1.X1, Cu1.X2, Cu2.X1, Cu2.X2, Cu3.X1,
Cu3.X2, Cu4.X1, Cu4.X2.
Remote command:
CURSor<m>:
LABel:
X<1..2> on page 1475
Y1 label, Y2 label
Defines a label to be displayed with the horizontal cursors. By defaYult, the cursors are
labeled as Cu1.Y1, Cu1.Y2, Cu2.Y1, Cu2.Y2, Cu3.Y1, Cu3.Y2, Cu4.Y1, Cu4.Y2.
Remote command:
CURSor<m>:LABel:Y<1..2> on page 1476
8.1.3.3 Peak Search tab
Access: [Cursor] key > "Peak Search" tab
The settings on this tab are only available in spectrum mode, i.e. the source of the cur-
sor measurement is an FFT math waveform. In this case, the cursors can indicate the
results of a peak search on the waveform. You can define which peaks the instrument
determines by defining the noise reject settings.
Cursor measurements
To Next Page
Loading...
