Power analysis (option R&S RTO6-K31)
R&S
®
RT
O6
1142User Manual 1801.6687.02 ─ 05
Custom frequency
Sets the user-defined frequency if the
"Input frequency" is set to "Custom".
Remote command:
POWer:
QUALity:FCUS on page 2528
Optimize scaling
Selects the scaling for the display of the results.
"Autoscale the signals"
Automatically selects the most appropriate scale for the display of the
results.
"Keep present settings"
The present display settings are not changed.
Remote command:
POWer:
QUALity:AUTO
on page 2527
Report comment
In this field you can write a comment that is displayed in the measurement report, for
example, a measurement description.
Execute
Starts the " Power Quality" measurement.
Remote command:
POWer:QUALity:EXECute on page 2527
19.3.2 Inrush current
The "Inrush Current" analysis measures the peak of the input current that is drawn by
the device, when the device is first turned on.
Required probes:
●
Current probe
19.3.2.1 Inrush current results
The results of " Inrush Current" measurements are provided in two ways:
●
The diagram shows the graphical presentation of:
– the current waveform
●
The result box displays the following numeric measurement results:
– "Start time" / "Stop time" define the time period for the present gate
– The "Value" stands for the maximum amplitude of the current for the present
time period. This is the inrush current for the correspondent gate.
Input
To Next Page
Loading...
