R&S RTO6 - 19.6.2.3 Transient response settings

Power analysis (option R&S RTO6-K31)
R&S
®
RT
O6
1192User Manual 1801.6687.02 ─ 05
6. Select the correct channels for the "Current Source" and the "Voltage Source".
7.
Select the "Settings" tab.
8.
Set the "Trigger" settings according to your signal.
9. Set the "Tube tolerance", "Signal high" and "Signal low" according to your require-
ments.
10. Set the "SMPS switching frequency" according to your device.
11. Select an "Optimize Scaling" option.
12. Tap "Execute".
13. If needed adjust the cursors manually.
On the screen, you can see the measurement of the current and the voltage . Also,
there is a table giving information about important measurement parameters. For
details, see Chapter 19.6.2.1, "Transient response results", on page 1190.
19.6.2.3 Transient response settings
In the "Channels" tab, you set the current source and the voltage sources, see also:
Chapter 19.2.1, "Channels tab", on page 1134 and POWer:TRANsient:INPut
on page 2555.
Output