R&S RTO6 - 24.7.2.9 Measurement appearance; 24.7.2.10 Peak list appearance

Remote control commands
R&S
®
RTO6
1315User Manual 1801.6687.02 ─ 05
24.7.2.9 Measurement appearance
MEASurement<m>:
DISPlay:GROuping
<GroupResDialogs>
If ON, all measurement results are shown in one result box. If disabled, the results of
each measurement group are shown in a separate result box. The default position is
ignored.
Suffix:
<m>
.
1..10
The suffix is irrelevant. The setting af
fects all measurements
except for the peak list.
Parameters:
<GroupResDialogs> ON | OFF
*RST: ON
Usage: Asynchronous command
DISPlay:RESultboxes:MEPosition <Position>
Defines the position of the measurement results on the display.
Parameters:
<Position> PREV | FLOA |
DOCK
PREV
Preview: result icon on the signal bar
FLOA
Floating: floating result box in front of the diagrams
DOCK
Docked: fixed tab below the diagrams
*RST: DOCK
Usage: Asynchronous command
24.7.2.10 Peak list appearance
MEASurement<m>:RESult:LABorder
<MeasType>, <FrameType>
MEASurement<m>:RESult:LABorder? <MeasType>
Defines the layout of the labels.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<FrameT
ype> NOBorder | UNDERLINE | FULL
NOBorder
Label without border or lines.
Instrument setup