R&S RTO6 - 24.27.2 Diagnostic remote trace commands; 24.28 Deprecated commands

Remote control commands
R&S
®
RTO6
2581User Manual 1801.6687.02 ─ 05
24.27.2 Diagnostic remote trace commands
TRACe:REMote:
MODE:
FILE:DEXecution:DURation........................................................2581
TRACe:REMote:MODE:FILE:RPC.................................................................................2581
TRACe:REMote:MODE:FILE:PARSer............................................................................ 2581
TRACe:REMote:MODE:FILE:FUNCtions........................................................................2581
TRACe:REMote:MODE:FILE:DEXecution:DURation <Enable>
Traces the device execution time of a command
Parameters:
<Enable> ON | OFF
TRACe:REMote:MODE:FILE:RPC <Enable>
Enables and disables output of rpc calls to remote trace.
Parameters:
<Enable> ON | OFF
TRACe:REMote:MODE:FILE:PARSer <Enable>
Enables and disables output of parser transitions to remote trace.
Parameters:
<Enable> ON | OFF
TRACe:REMote:MODE:FILE:FUNCtions <Enable>
Enables and disables output of function names to remote trace.
Parameters:
<Enable> ON | OFF
24.28 Deprecated commands
The following commands are provided for compatibility to previous oscilloscope ver-
sions only
. For new remote control programs, use the specified alternative commands.
Deprecated commands