R&S RTO6 - 10.4.2 Setting up a mask test; 10.4.3 Configuring the mask and hit display

Mask testing
R&S
®
RTO6
416User Manual 1801.6687.02 ─ 05
10.4.2 Setting up a mask test
In addition to the mask definition, the mask test contains further settings:
●
The waveform to be tested
●
The criteria for a failed test
●
The actions to be taken if a test has failed or has been completed successfully
1.
Open [App Cockpit] > "Analysis" tab > "Mask" > "Define Mask" tab.
2.
Select the "Target" to be tested.
3. Select the "Define Test" tab.
4. Set the conditions for a failed test:
a) " Fail condition": select if sample hits or the number of acquisitions with sample
hits are considered.
b) "Violation tolerance": number of tolerable sample hits or acquisition hits.
A test has failed if the number of sample hits or acquisition hits exceeds the limit of
violation tolerance hits.
5. Tap "Action on mask".
6. For each action, select when the action will be executed:
● "On violation" if the mask test has failed
● "On successful completion"
10.4.3 Configuring the mask and hit display
The display of masks and mask violation is the same for all mask tests .
The settings mentioned here are described in detail in Chapter 10.2.3, "Define T
est",
on page
405.
1. Open [App Cockpit] > "Analysis" tab > "Mask".
2. Select the "Display" tab.
3. Select "Show mask" to display the masks of all enabled mask tests on the screen.
4. Open "Menu" > "Settings" >"Appearance" dialog.
5. Select the "Mask" tab.
6. Define how the sample hits are displayed:
a) Select "Show hits" to display the sample hits.
b) Set the "Show for" time or "Show hits forever".
c) Set the "Color" of the sample hits.
7. Define the color of the masks segments depending on the violation state:
● Mask without violation
● Mask with violation
Working with masks