R&S RTO6 - 24.15.1 General search settings

Remote control commands
R&S
®
RTO6
1604User Manual 1801.6687.02 ─ 05
● General search settings......................................................................................
1604
● Basic trigger search conditions...........................................................................
1606
● Edge search conditions.......................................................................................1608
● Glitch search conditions......................................................................................1608
● Interval search conditions................................................................................... 1610
● Runt search conditions........................................................................................1611
● Slew rate search conditions................................................................................ 1614
● Timeout search conditions.................................................................................. 1616
● Width search conditions......................................................................................1617
● Window search conditions.................................................................................. 1619
● Data2clock search conditions............................................................................. 1621
● Pattern search conditions....................................................................................1623
● State search conditions.......................................................................................1628
● Search on spectrum............................................................................................1630
● Search gate settings........................................................................................... 1631
● Search results..................................................................................................... 1634
24.15.1 General search settings
SEARch:ADD.............................................................................................................. 1604
SEARch:CLEar............................................................................................................1604
SEARch:REMove.........................................................................................................1605
SEARch:SOURce........................................................................................................ 1605
SEARch:ONLine.......................................................................................................... 1605
SEARch:ALL............................................................................................................... 1605
SEARch:ADD <SearchName>
Creates a new search definition with the specified name.
Setting parameters:
<SearchName> String with the name of the search
Example: See Chapter 24.3.4.1, "Searching for a pulse of specified width",
on page
1266
Usage: Setting only
Asynchronous command
SEARch:CLEar <SearchName>
Clears the search results once to start a new search.
Setting parameters:
<SearchName> Search definition
Usage: Setting only
Asynchronous command
Search