Remote control commands
R&S
®
RTO6
1778User Manual 1801.6687.02 ─ 05
<n> *
<o> *
Parameters:
<IndexOperator> EQUal | INRange | RANGe
*RST: INRange
24.17.7.4 Decode results
In all BUS<m>:CSMB:
RESult<n> commands, the suffix <m> selects the serial bus, the
suffix <n> selects the result number in the decode table, and the suffix <o> selects the
cell number.
The following is an example for a set of query commands for bus 1 and result 1 is
shown in the following, together with examples for outcomes of these queries:
●
:BUS1:CMSB:RCOunt? !5
●
:BUS1:CMSB:RESult1:STATe? !OK
●
:BUS1:CMSB:RESult1:STARt? ! -0.0024964177
●
:BUS1:CMSB:RESult1:STOP? ! -0.0024030384
●
:BUS1:CMSB:RESult1:TYPE? !ff
●
:BUS1:CMSB:RESult1:CONE? !0b11111111
●
:BUS1:CMSB:RESult1:CTWO? !0xAA
●
:BUS1:CMSB:RESult1:CTHR? !0xF590
●
:BUS1:CMSB:RESult1:CCOunt? !5
●
:BUS1:CMSB:RESult1:CELL1:STAT? !OK
●
:BUS1:CMSB:RESult1:CELL1:NAME? !Start Delim
●
:BUS1:CMSB:RESult1:CELL1:VALue? !101010101HL10HL0
●
:BUS1:CMSB:RESult1:CELL2:STAT? !OK
●
:BUS1:CMSB:RESult1:CELL2:NAME? !OP-FF
●
:BUS1:CMSB:RESult1:CELL2:VALue? !0b11111111
●
:BUS1:CMSB:RESult1:CELL3:STAT? !OK
●
:BUS1:CMSB:RESult1:CELL3:NAME? !data
●
:BUS1:CMSB:RESult1:CELL3:VALue? !0xAA
●
:BUS1:CMSB:RESult1:CELL4:STAT? !OK
●
:BUS1:CMSB:RESult1:CELL4:NAME? !CRC
●
:BUS1:CMSB:RESult1:CELL4:VALue? !0xF590
Protocols
To Next Page
Loading...
