R&S RTO6 - 24.12.1 General settings

Remote control commands
R&S
®
RTO6
1480User Manual 1801.6687.02 ─ 05
● Statistics and long-term measurements..............................................................
1533
● Protocol
...............................................................................................................1539
● Track and trend...................................................................................................1545
● Gating..................................................................................................................1546
● Limit check and event actions.............................................................................1549
● Reference levels................................................................................................. 1552
24.12.1 General settings
MEASurement<m>[:ENABle].........................................................................................1480
MEASurement<m>:SOURce.........................................................................................1480
MEASurement<m>:FSRC.............................................................................................1482
MEASurement<m>:SSRC.............................................................................................1482
MEASurement<m>:CATegory........................................................................................1482
MEASurement<m>:MAIN..............................................................................................1483
MEASurement<m>:ADDitional.......................................................................................1484
MEASurement<m>:AON...............................................................................................1485
MEASurement<m>:AOFF............................................................................................. 1485
MEASurement<m>[:ENABle] <State>
Switches the indicated measurement on or off.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page
1479.
Parameters:
<State> ON |
OFF
*RST: OFF
Example: See "Simple frequency and amplitude measurement"
on page
1262.
Usage: Asynchronous command
MEASurement<m>:SOURce <SignalSource>, [<SignalSource2>]
Defines the source of the measurement. Availability of sources depends on the
selected category and installed options.
Suffix:
<m>
.
1..10
See
"Selection of the measurement group: MEASurement<m>"
on page 1479.
Automatic measurements