R&S RTO6 - Page 1482

Remote control commands
R&S
®
RTO6
1482User Manual 1801.6687.02 ─ 05
MEASurement<m>:FSRC <Source>
Defines the first measurement source.
The command is an alternative to MEASurement<m>:
SOURce.
Suffix:
<m>
.
1..10
See
"Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<Source> Source of the measurement, see MEASurement<m>:SOURce
on page
1480.
*RST: C1W1
Usage: Asynchronous command
MEASurement<m>:SSRC <Source2>
Defines the second measurement source.
The command is an alternative to MEASurement<m>:SOURce.
Suffix:
<m>
.
1..10
See
"Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<Source2> Second source of the measurement, see MEASurement<m>:
SOURce on page 1480
.
Digital channels are only available if a digital channel is set as
first measurement source using MEASurement<m>:FSRC.
*RST: C2W1
Usage: Asynchronous command
MEASurement<m>:CATegory <Category>
Defines the measurement category.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<Category>
AMPTime | JITTer | EYEJitter | SPECtrum | HISTogram |
PROT
ocol | OPT
ical
AMPTime
Amplitude and time measurements
Automatic measurements