R&S RTO6 - 8.2.8.5 Settings for histogram measurement

Measurements
R&S
®
RTO6
346User Manual 1801.6687.02 ─ 05
Remote command:
LAYout:
HISTogram:
MODE on page 1523
Reset
Resets the values to begin a new histogram.
Remote command:
LAYout:HISTogram:RESet on page 1527
Mode (Horizontal / Vertical)
Defines whether the value range limits are entered as absolute or relative values.
Remote command:
LAYout:HISTogram:HORZ:MODE on page 1524
LAYout:HISTogram:VERTical:MODE on page 1525
Start, Stop (Horizontal)
Defines the horizontal value range of the histogram.
Remote command:
LAYout:HISTogram:HORZ:ABSolute:STARt on page 1524
LAYout:HISTogram:HORZ:ABSolute:STOP on page 1524
LAYout:HISTogram:HORZ:RELative:STARt on page 1525
LAYout:HISTogram:HORZ:RELative:STOP on page 1525
Start, Stop (Vertical)
Defines the vertical value range of the histogram.
Remote command:
LAYout:HISTogram:VERTical:ABSolute:STARt on page 1526
LAYout:HISTogram:VERTical:ABSolute:STOP on page 1526
LAYout:HISTogram:VERTical:RELative:STARt on page 1526
LAYout:HISTogram:VERTical:RELative:STOP on page 1526
8.2.8.5 Settings for histogram measurement
Access: [Measure] > "Setup" tab > "Histogram" category
Y
ou can perform measurements on histograms. Before, you have to define a histo-
gram, see
Chapter 8.2.8.3, "Creating histograms", on page 344.
Automatic measurements