R&S RTO6 - 24.8.1 Starting and stopping acquisition

Remote control commands
R&S
®
RTO6
1325User Manual 1801.6687.02 ─ 05
To prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www
.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
●
Chapter 24.3, "Programming examples", on page
1259
● Starting and stopping acquisition........................................................................ 1325
● Time base........................................................................................................... 1326
● Acquisition...........................................................................................................1332
● Fast segmentation...............................................................................................1336
● Vertical................................................................................................................ 1337
● Waveform data....................................................................................................1342
● Probes.................................................................................................................1343
● R&S RT-ZVC probe.............................................................................................1366
● Differential signals...............................................................................................1379
● Digital filter.......................................................................................................... 1382
● Skew................................................................................................................... 1384
● AUX OUT............................................................................................................ 1385
● High definition mode........................................................................................... 1386
● Reference clock.................................................................................................. 1388
24.8.1 Starting and stopping acquisition
RUNContinous.............................................................................................................1325
RUN........................................................................................................................... 1325
RUNSingle.................................................................................................................. 1325
SINGle........................................................................................................................1325
STOP......................................................................................................................... 1326
RUNContinous
RUN
Starts the continuous acquisition.
Usage: Event
Asynchronous command
RUNSingle
SINGle
Starts a defined number of acquisition cycles. The number of cycles is set with
ACQuire:COUNt
.
Usage: Event
Asynchronous command
Acquisition and setup