Remote control commands
R&S
®
RTO6
1678User Manual 1801.6687.02 ─ 05
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<Technology> V15 | V25 | V165 | V125 | V09 | VM13 | V38 | V20 | V0 | MANual
V15 | V25 | V165 | V125 | V09 | V38 | V20 | V0
1.5 V, 2.5 V
, 1.65 V ... respectively
VM13
-1.3 V (negative value)
MANual
Manual setting of user-defined values with BUS<m>:I2C:SCL:
THReshold and BUS<m>:I2C:SDA:THReshold.
*RST: V165
BUS<m>:I2C:RWBit <BusConfig>
Defines if the R/W bit of a 7-bit address is considered separately or as part of the
address. 10-bit addresses are not affected. The setting defines which address lengths
are available with TRIGger<m>:
I2C:AMODe.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<BusConfig> SEParate | INADdress
SEParate
7-bit address and separate R/W bit.
INADdress
8-bit address with R/W bit included.
*RST: SEParate
24.17.3.2 Trigger
The trigger suffix <m> is always 1 and can be omitted. It selects the trigger event: Only
the A-trigger is available for triggering on serial buses.
To trigger on a serial bus, make sure that:
●
TRIGger<m>:SOURce[:SELect] is set to SBUS.
●
The sources of the serial bus are channel signals: use BUS<m>:...:SOURce
commands.
●
Decoding is enabled: BUS<m>[:STATe] is set to ON.
TRIGger<m>:I2C:TYPE................................................................................................1679
TRIGger<m>:I2C:ACCess.............................................................................................1679
TRIGger<m>:I2C:ADNack.............................................................................................1680
TRIGger<m>:I2C:DWNack............................................................................................1680
TRIGger<m>:I2C:DRNack............................................................................................ 1680
Protocols
To Next Page
Loading...
