R&S RTO6 - 13.9.2 FlexRay trigger; 13.9.2.1 FlexRay trigger

Protocol analysis
R&S
®
RTO6
623User Manual 1801.6687.02 ─ 05
1. Press the [Bus] key on the front panel.
2.
Select the tab of the bus you want to set up, for example "SB1".
3.
Select the "Setup" tab.
4. Tap the "Protocol" button and select the protocol: "FlexRay".
5. Select the "Source type".
6. Select the channels for the sources.
7. Adjust other settings, if necessary.
8. Set the logical thresholds.
9. Enable "Decode".
13.9.2 FlexRay trigger
13.9.2.1 FlexRay trigger
Access: [Bus] > "Shortcuts" tab > "Setup trigger"
Make sure that:
●
In the [Bus] > "Setup" tab:
– The correct "Protocol" is selected.
– The data sources of the serial bus are channel signals.
●
In the "Trigger" > "Setup" tab:
– The "Trigger on" = "Single event"
– The trigger "Source" = "Serial bus".
– The correct "Serial bus" is selected.
FlexRay (option R&S RT
O6-K520)