Protocol analysis
R&S
®
RTO6
746User Manual 1801.6687.02 ─ 05
Access: [Bus] > "Display" tab.
For common display settings, see Chapter 13.1.3, "Display", on page 487.
MDIO Specific Label Settings
Decode layer
Selects the decode layer
.
Decoding is performed in several steps, and the end results are presented in the
decode table. The decode layer selects an interim step for which the decoding result is
shown in the honeycomb display.
Available are:
●
"Final"
●
"Edges"
●
"Binary"
13.16.2.3 Configuring MDIO signals
For configuration, assign the lines to the input channels and define the active states
and the logical thresholds.
For details on configuration settings, see Chapter 13.16.2.1, "MDIO configuration set-
tings", on page
743.
1.
Press the [Bus] key on the front panel.
MDIO (option R&S RT
O6-K540)
To Next Page
Loading...
