R&S RTO6 - 24.7.5 Save; recall; 24.7.6 Maintenance; 24.7.6.1 Self-alignment

Remote control commands
R&S
®
RTO6
1322User Manual 1801.6687.02 ─ 05
USRDefined:RST:SAVE
Saves the current instrument settings to a user-defined preset file. Name and path of
the preset file are defined with USRDefined:
RST:
NAME.
Usage: Event
USRDefined:RST[:ENABle] <Name>
If ON, the settings from a previously defined preset file are restored when the [Preset]
key is pressed. The preset file is defined with USRDefined:
RST:NAME.
If OFF, [Preset] sets the instrument to the factory defaults.
Parameters:
<Name> ON | OFF
*RST: OFF
24.7.5 Save / recall
See the following chapters:
●
Chapter 24.16.10, "Autonaming", on page 1666
●
Chapter 24.16.11, "CSV export",
on page 1668
●
Chapter 24.16.12, "External application", on page 1668
24.7.6 Maintenance
24.7.6.1 Self-alignment
CALibration:DATE?...................................................................................................... 1322
CALibration:TIME?.......................................................................................................1322
CALibration:RESult?.....................................................................................................1323
CALibration:DATE?
Returns the date of the last selfalignment.
Return values:
<Date>
Usage: Query only
Asynchronous command
CALibration:TIME?
Returns the time of the last selfalignment.
Instrument setup