R&S RTO6 - 24.13 Spectrum analysis; 24.13.1 Basic FFT

Remote control commands
R&S
®
RTO6
1565User Manual 1801.6687.02 ─ 05
Return values:
<TopInner> Range: -100E+24 to 100E+24
*RST: 0
Usage: Query only
Asynchronous command
MEASurement<m>:REFLevel:RESult:TOUTer?
Returns the area above the high signal level which is still considered to be high level.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Return values:
<T
opOuter> Range: -100E+24 to 100E+24
*RST: 0
Usage: Query only
Asynchronous command
24.13 Spectrum analysis
Some of the commands in the following chapter are asynchronous. An overlapping or
asynchronous command does not automatically finish executing before the next com-
mand starts executing. If overlapping commands must be executed in a defined order
,
e.g. to avoid wrong measurement results, they must be serviced sequentially.
T
o prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
●
Chapter 24.3, "Programming examples", on page 1259
24.13.1 Basic FFT
CALCulate:MATH<m>:FFT:LOGScale............................................................................1566
CALCulate:MATH<m>:FFT:STARt..................................................................................1566
CALCulate:MATH<m>:FFT:STOP.................................................................................. 1567
CALCulate:MATH<m>:FFT:CFRequency........................................................................1567
CALCulate:MATH<m>:FFT:FULLspan............................................................................1567
CALCulate:MATH<m>:FFT:SPAN.................................................................................. 1568
CALCulate:MATH<m>:FFT:TYPE.................................................................................. 1568
CALCulate:MATH<m>:FFT:BANDwidth[:RESolution]:ADJusted?.......................................1568
CALCulate:MATH<m>:FFT:BANDwidth[:RESolution]:AUTO..............................................1569
Spectrum analysis