R&S RTO6 - 18.1.4 Track of jitter measurement results

Jitter analysis and clock data recovery
R&S
®
RTO6
1078User Manual 1801.6687.02 ─ 05
2. In the overlay menu, enable "Statistics state".
3.
T
ap "Advanced Setup".
4. On the "Measure" > "Advanced" tab, enable "Measure all events in each acquisi-
tion".
The histogram plots the density of data. It shows the frequency of occurrence of the
measurement values. The maximum count of a measurement value is assigned to the
full height of the histogram diagram (= 1000). All other count values are displayed rela-
tive to the maximum.
To enable the histogram
1. On the "Plot" tab, enable the "Histogram".
2. If the histogram is not displayed as expected, disable "Continuous auto scale" and
adjust the "Meas scale".
18.1.4 Track of jitter measurement results
A track graph displays the results of the first jitter measurement from a single acquisi-
tion as a time-correlated waveform. To generate the track graph, multiple measurement
points are required. Thus, enabling the track automatically activates "Measure all
events in each acqu.".
You can measure amplitude and time on the track waveform: Configure a new mea-
surement group, e.g. "MG2", that uses the track waveform as measurement source.
You can also zoom into the track waveform, perform cursor measurements on it, and
export the track.
Jitter measurements (options R&S R
T
O6-K12/K13)