Protocol analysis
R&S
®
RTO6
968User Manual 1801.6687.02 ─ 05
Before you can start the search, you have to configure the bus correctly and acquire
decoded data.
T
o search on decoded data, set the search source to
"SerBus" for the configured proto-
col.
For general information on how to handle the search functionality, see Chapter 11,
"Search functions", on page 419.
If you need information on how to get started with searching for DDR data, see Chap-
ter 13.27.2.3, "Searching for DDR data", on page 971. Otherwise proceed with the
DDR search setup.
13.27.2.1 DDR search setup
Access: [Bus] > "Shortcuts" tab > "Setup search"
In this dialog, you can define the search type for DDR.
DDR search
You can select one or more frames to be searched for
. Available are "Read", "Write, ",
"Read NC" and "Write NC ". You can also define the data and/or index operators and
values for the field, see Set details.
Remote command:
SEARch:TRIGger:DDR:FRENable on page 2395
SEARch:TRIGger:DDR:FRAMe<m>:ENABle on page 2396
DDR (option R&S R
T
O6-K91 )
To Next Page
Loading...
