R&S RTO6 - 24.21 I;Q software interface (option R&S RTO6-K11); 24.21.1 I;Q sampling settings

Remote control commands
R&S
®
RTO6
2472User Manual 1801.6687.02 ─ 05
24.21 I/Q software interface (option R&S RTO6-K1
1)
Some of the commands in the following chapter are asynchronous. An overlapping or
asynchronous command does not automatically finish executing before the next com-
mand starts executing. If overlapping commands must be executed in a defined order,
e.g. to avoid wrong measurement results, they must be serviced sequentially.
To prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
●
Chapter 24.3, "Programming examples", on page 1259
● I/Q sampling settings...........................................................................................2472
● I/Q data output.................................................................................................... 2477
● NFC trigger..........................................................................................................2478
24.21.1 I/Q sampling settings
To switch on the input channels, use CHANnel<m>:STATe.
Some of the commands in the following chapter are asynchronous. An overlapping or
asynchronous command does not automatically finish executing before the next com-
mand starts executing. If overlapping commands must be executed in a defined order,
e.g. to avoid wrong measurement results, they must be serviced sequentially.
To prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
●
Chapter 24.3, "Programming examples", on page 1259
IQ:STATe.....................................................................................................................2473
IQ:INSRate..................................................................................................................2473
CHANnel<m>:IQ:INPType.............................................................................................2473
CHANnel<m>:IQ:INPMode............................................................................................2473
IQ:RBWidth................................................................................................................. 2474
IQ:BWIDth?.................................................................................................................2474
IQ:SRATe.................................................................................................................... 2474
IQ:RLENgth.................................................................................................................2474
CHANnel<m>:IQ:CFRequency...................................................................................... 2475
CHANnel<m>:IQ:SBRF................................................................................................ 2475
CHANnel<m>:IQ:SBIF..................................................................................................2476
CHANnel<m>:IQ:WARNing[:STATe]?............................................................................. 2476
CHANnel<m>:IQ:WARNing:MESSage?..........................................................................2476
I/Q software interface (option R&S R
T
O6-K11)