R&S RTO6 - 13.10.3 SENT trigger; 13.10.3.1 SENT trigger settings

Protocol analysis
R&S
®
RTO6
643User Manual 1801.6687.02 ─ 05
13.10.3 SENT trigger
13.10.3.1 SENT trigger settings
Access: [Bus] > "Shortcuts" tab > "Setup trigger"
Make sure that:
●
In the [Bus] > "Setup" tab:
–
The correct "Protocol" is selected.
– The data sources of the serial bus are channel signals.
●
In the "Trigger" > "Setup" tab:
– The "Trigger on" = "Single event"
– The trigger "Source" = "Serial bus".
– The correct "Serial bus" is selected.
Type
Selects the event of the SENT transmission sequence or message to be triggered on.
The RT
O6 triggers always on the falling edge of a pulse, i.e. at the end of the selected
type nibble in a transmission sequence.
"Calibration or Sync"
Triggers at the end of the "Synchronization/Calibration" pulse.
This setting does not require any input parameters.
SENT (option R&S RT
O6-K520)