R&S RTO6 - 24.17.25.3 Decode results M-PHY

Remote control commands
R&S
®
RTO6
2292User Manual 1801.6687.02 ─ 05
Parameters:
<ErrorLength> ON | OFF
*RST: ON
TRIGger<m>:MPHY:ERRor:REServed <ErrorReserved>
Enables/disables trigger on reserved bit error.
Suffix:
<m>
.
1..3
Parameters:
<ErrorReserved>
ON | OFF
*RST: ON
TRIGger<m>:MPHY:ERRor:SYMBol <ErrorSymbol>
Enables/disables trigger on 8b10b symbol error.
Suffix:
<m>
.
1..3
Parameters:
<ErrorSymbol>
ON | OFF
*RST: ON
TRIGger<m>:MPHY:ERRor:UNKNown <ErrorUnknown>
Enables/disables trigger on unidentified UniPro frame error.
Suffix:
<m>
.
1..3
Parameters:
<ErrorUnknown>
ON | OFF
*RST: ON
24.17.25.3 Decode results M-PHY
To show the results on the screen, use the following commands:
●
BUS<m>:
RESult on page 1671
BUS<m>:MPHY:RESult:FRAMe<n>:FTYPe?..................................................................2293
BUS<m>:MPHY:RESult:FRAMe<n>:STATe?...................................................................2294
BUS<m>:MPHY:RESult:FCOunt?..................................................................................2294
BUS<m>:MPHY:RESult:FRAMe<n>:CCOunt?................................................................ 2295
BUS<m>:MPHY:RESult:FRAMe<n>:CELL<o>:DATA?..................................................... 2295
BUS<m>:MPHY:RESult:FRAMe<n>:CELL<o>:STARt?.................................................... 2295
BUS<m>:MPHY:RESult:FRAMe<n>:CELL<o>:STOP?.....................................................2296
BUS<m>:MPHY:RESult:FRAMe<n>:CELL<o>:STATe?....................................................2296
Protocols