R&S RTO6 - Page 2293

Remote control commands
R&S
®
RTO6
2293User Manual 1801.6687.02 ─ 05
BUS<m>:MPHY:RESult:FRAMe<n>:CELL<o>:TYPE?.....................................................
2297
BUS<m>:MPHY
:RESult:FRAMe<n>:DATA?....................................................................2297
BUS<m>:MPHY:RESult:FRAMe<n>:INFO?.................................................................... 2297
BUS<m>:MPHY:RESult:FRAMe<n>:SSFT?....................................................................2298
BUS<m>:MPHY:RESult:FRAMe<n>:STARt?...................................................................2298
BUS<m>:MPHY:RESult:FRAMe<n>:STOP?................................................................... 2298
BUS<m>:MPHY:RESult:FRAMe<n>:FTYPe?
Returns the type of frame for the selected frame.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
Selects the frame.
Return values:
<FrameType> BURST | ADAPT | LCC | DLPDUSOF | DLPDUCOF |
DLPDUEOF | DLPDUNAC | DLPDUAFC | P
ACP | TRIGUPR0 |
TRIGUPR1 | TRIGUPR2 |
SKIP | FILLER | SPACER |
UNKNOWN
BURST
M-PHY burst frame.
ADAPT
M-PHY Adapt frame. This control frame is used for clock/bit syn-
chronization.
LCC
M-PHY LCC frame. This control frame is used for line configura-
tion depending on the LCC Type.
DLPDUSOF | DLPDUCOF | DLPDUEOF | DLPDUNAC |
DLPDUAFC
UniPro DL PDU frame.
PACP
UniPro frame. This control frame is used mainly for power mode
change and L1.5 link management.
TRIGUPR0 | TRIGUPR1 | TRIGUPR2
UniPro frame. This control frame is used for link startup
sequence.
SKIP
UniPro frame with Skip symbols for reducing protocol payload
bandwidth.
FILLER
M-PHY or UniPro frame with filler words to maintain transmis-
sion activity.
SPACER
Scrambled UniPro frame with filler words.
Protocols