R&S RTO6 - 24.15.3 Edge search conditions; 24.15.4 Glitch search conditions

Remote control commands
R&S
®
RTO6
1608User Manual 1801.6687.02 ─ 05
SEARch:TRIGger:STATe:ACOPy <SearchName>
SEARch:TRIGger:TIMeout:ACOPy <SearchName>
SEARch:TRIGger:WIDTh:ACOPy <SearchName>
SEARch:TRIGger:WINDow:ACOPy <SearchName>
Copies the trigger event configuration from T
rigger A for the selected channel source to
the search condition settings.
See
Chapter 6.3, "Trigger types", on page 193.
Setting parameters:
<SearchName> Search definition
Usage: Setting only
Asynchronous command
SEARch:TRIGger:EDGE:BCOPy <SearchName>
Copies the trigger event configuration from trigger B for the selected channel source to
the search condition settings.
Setting parameters:
<SearchName> String with name of the search
Usage: Setting only
Asynchronous command
24.15.3 Edge search conditions
Trigger level setting: SEARch:TRIGger:
LEVel[:VALue] on page 1607
SEARch:TRIGger:EDGE:SLOPe................................................................................... 1608
SEARch:TRIGger:EDGE:SLOPe <SearchName>,<Slope>
SEARch:TRIGger:EDGE:SLOPe? <SearchName>
Selects the edge type.
Parameters:
<Slope> POSitive | NEGative | EITHer
See Chapter 24.4.3, "Slope parameter", on page 1285.
*RST
: POSitive
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
24.15.4 Glitch search conditions
Trigger level setting: SEARch:TRIGger:LEVel[:VALue] on page 1607
Search