Remote control commands
R&S
®
RTO6
1628User Manual 1801.6687.02 ─ 05
24.15.13 State search conditions
SEARch:TRIGger:ST
A
Te:CSOurce................................................................................ 1628
SEARch:TRIGger:STATe:CEDGe.................................................................................. 1628
SEARch:TRIGger:STATe:CLEVel...................................................................................1628
SEARch:TRIGger:STATe:A[:ENABle]............................................................................. 1629
SEARch:TRIGger:STATe:B[:ENABle]............................................................................. 1629
SEARch:TRIGger:STATe:C[:ENABle]............................................................................. 1629
SEARch:TRIGger:STATe:D[:ENABle]............................................................................. 1629
SEARch:TRIGger:STATe:A:LOGic................................................................................. 1629
SEARch:TRIGger:STATe:B:LOGic................................................................................. 1629
SEARch:TRIGger:STATe:C:LOGic................................................................................. 1629
SEARch:TRIGger:STATe:D:LOGic................................................................................. 1629
SEARch:TRIGger:STATe:AB:LOGic............................................................................... 1630
SEARch:TRIGger:STATe:CD:LOGic...............................................................................1630
SEARch:TRIGger:STATe:ABCD:LOGic...........................................................................1630
SEARch:TRIGger:STATe:CSOurce <SearchName>,<Source>
SEARch:TRIGger:STATe:CSOurce? <SearchName>
Sets the source of the clock signal.
Parameters:
<Source> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 |
M8 | R1 |
R2 | R3 | R4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 |
D7 | D8 | D9 | D10 | D11 | D12 | D13 | D14 | D15
Parameters for setting and query:
<SearchName> String with the name of the search
Usage: Asynchronous command
SEARch:TRIGger:STATe:CEDGe <SearchName>,<ClockEdge>
SEARch:TRIGger:STA
Te:CEDGe? <SearchName>
Sets the trigger edge of the clock signal.
Parameters:
<ClockEdge> POSitive | NEGative | EITHer
*RST: POSitive
Parameters for setting and query:
<SearchName> String with the name of the search
Usage: Asynchronous command
SEARch:TRIGger:STATe:CLEVel <SearchName>,<ClockLevel>
SEARch:TRIGger:STA
Te:CLEVel? <SearchName>
Sets the trigger level of the clock signal.
The command has the same effect as with SEARch:TRIGger:LEVel[:VALue].
Search
To Next Page
Loading...
