Remote control commands
R&S
®
RTO6
2090User Manual 1801.6687.02 ─ 05
Parameters:
<SymbolRate> Range: 10 to 150
Increment: 1E-3
*RST: 66.6667
Default unit: MSymb/s
24.17.19.2 Trigger
The trigger suf
fix <m> is always 1 and can be omitted. It selects the trigger event: Only
the A-trigger is available for triggering on serial buses.
To trigger on a serial bus, make sure that:
●
TRIGger<m>:SOURce[:SELect] is set to SBUS.
●
The sources of the serial bus are channel signals: use BUS<m>:...:SOURce
commands.
●
Decoding is enabled: BUS<m>[:STATe] is set to ON.
TRIGger<m>:HBTO:TYPE............................................................................................ 2090
TRIGger<m>:HBTO:DADDress:CONDition.....................................................................2091
TRIGger<m>:HBTO:DADDress:MIN.............................................................................. 2091
TRIGger<m>:HBTO:DADDress:MAX............................................................................. 2092
TRIGger<m>:HBTO:SADDress:CONDition..................................................................... 2092
TRIGger<m>:HBTO:SADDress:MIN...............................................................................2092
TRIGger<m>:HBTO:SADDress:MAX..............................................................................2093
TRIGger<m>:HBTO:LENGth:CONDition.........................................................................2093
TRIGger<m>:HBTO:LENGth:MIN.................................................................................. 2093
TRIGger<m>:HBTO:LENGth:MAX................................................................................. 2093
TRIGger<m>:HBTO:CRC:CONDition............................................................................. 2094
TRIGger<m>:HBTO:CRC:MIN.......................................................................................2094
TRIGger<m>:HBTO:CRC:MAX......................................................................................2094
TRIGger<m>:HBTO:DATA:DCONdition.......................................................................... 2095
TRIGger<m>:HBTO:DATA:DMIN................................................................................... 2095
TRIGger<m>:HBTO:DATA:DMAX.................................................................................. 2095
TRIGger<m>:HBTO:DATA:ICONdition............................................................................2096
TRIGger<m>:HBTO:DATA:IMIN.....................................................................................2096
TRIGger<m>:HBTO:DATA:IMAX....................................................................................2096
TRIGger<m>:HBTO:ERRor:PREamble...........................................................................2096
TRIGger<m>:HBTO:ERRor:CRC...................................................................................2097
TRIGger<m>:HBTO:ERRor:SFD....................................................................................2097
TRIGger<m>:HBTO:TYPE <Type>
Selects the type of frame to be triggered on.
Suffix:
<m>
.
1..3
Parameters:
<Type> STARt | MAC | IDLE | ERRor
Protocols
To Next Page
Loading...
