Remote control commands
R&S
®
RTO6
1313User Manual 1801.6687.02 ─ 05
DISPlay:SIGNal:LABel:HORizontal:RELative:POSition <LabelID>, <Source>,
<Position>
DISPlay:SIGNal:LABel:HORizontal:RELative:POSition
?
<LabelID>, <Source>
DISPlay:SIGNal:LABel:VERTical:RELative:POSition <LabelID>, <Source>,
<Position>
DISPlay:SIGNal:LABel:VERTical:RELative:POSition? <LabelID>, <Source>
Modifies or queries the relative horizontal and vertical positiions of the specified label if
DISPlay:SIGNal:LABel:POSMode is set to REL.
Parameters:
<Position> Position in percent of the screen counting from the upper left
corner.
Range:
0 to 100
Default unit: %
Parameters for setting and query:
<LabelID> String with the label identifier.
<Source> All waveforms that can be displayed, see DISPlay:
SIGNal:
LABel:
ADD
Example:
:DISPlay:SIGNal:LABel:POSMode C2W1, REL
DISPlay:SIGNal:LABel:HORizontal:RELative:POSition 'Label1', C2W1, 30
DISPlay:SIGNal:LABel:VERTical:RELative:POSition 'Label1', C2W1, 70
Move the label to new relative position: horizontal at 30 % and
vertical at 70 % of the screen.
24.7.2.7 Dialog appearance
DISPlay:EXTended:PORDialogs <PopOutResDialogs>
If an external monitor is connected to the instrument, enables the display of result
boxes on the external monitor
.
Parameters:
<PopOutResDialogs> ON | OFF
*RST: OFF
DISPlay:EXTended:POSDialogs <PopOutSettDialogs>
If an external monitor is connected to the instrument, enables the display of dialog
boxes on the external monitor.
Parameters:
<PopOutSettDialogs>
ON | OFF
*RST: OFF
Instrument setup
To Next Page
Loading...
