Remote control commands
R&S
®
RTO6
1941User Manual 1801.6687.02 ─ 05
SLEEP
T
riggers on a SLEEP frame. Optionally you can define an NM, a
CT
, a data pattern condition and an index condition.
LONG
Triggers on a Long frame. Optionally you can define a frame ID
condition, an NM, a CT, a DLC extend condition, a data pattern
condition and an index condition.
LPOLl
Triggers on a Long POLL frame.
PID
Triggers on a Protected ID field. Optionally, you can define the
frame ID pattern.
PTYPe
Triggers on a Protected TYPE field.
PTPID
Triggers on a Protected Type field followed by a PID field.
Optionally, you can define the frame ID pattern.
ERRor
Trigger on selected error types. Define the error types with:
TRIGger<m>:CXPI:ERRor:CRC
TRIGger<m>:CXPI:ERRor:DLC
TRIGger<m>:CXPI:ERRor:IBS
TRIGger<m>:CXPI:ERRor:IFS
TRIGger<m>:CXPI:ERRor:LENGth
TRIGger<m>:CXPI:ERRor:PARity
TRIGger<m>:CXPI:ERRor:UART
*RST: STARt
24.17.12.3 Decode results
To show the results on the screen, use the following commands:
●
BUS<m>:
RESult on page 1671
BUS<m>:CXPI:RESult:FCOunt?....................................................................................1941
BUS<m>:CXPI:RESult:FRAMe<n>:DATA?..................................................................... 1942
BUS<m>:CXPI:RESult:FRAMe<n>:DLCV?.....................................................................1942
BUS<m>:CXPI:RESult:FRAMe<n>:STARt?.................................................................... 1942
BUS<m>:CXPI:RESult:FRAMe<n>:STATe?.................................................................... 1943
BUS<m>:CXPI:RESult:FRAMe<n>:STOP?.....................................................................1943
BUS<m>:CXPI:RESult:FRAMe<n>:TYPE?.....................................................................1943
BUS<m>:CXPI:RESult:FRAMe<n>:WORD<o>:STATus?..................................................1944
BUS<m>:CXPI:RESult:FRAMe<n>:WORD<o>:TYPE?.................................................... 1944
BUS<m>:CXPI:RESult:FRAMe<n>:WORD<o>:VALue?................................................... 1944
BUS<m>:CXPI:RESult:FCOunt?
Returns the number of frames in the acquisition.
Protocols
To Next Page
Loading...
