R&S RTO6 - 13.17.3.2 Triggering on RFFE signals; 13.17.4 RFFE label list

Protocol analysis
R&S
®
RTO6
768User Manual 1801.6687.02 ─ 05
"Condition"
Sets the operator to trigger on a specific mask frame ("Equal") or a
mask frame range.
"Mask (Min)"
Defines the mask pattern for all operators that require one pattern.
"Mask (Max)"
Defines the second mask pattern that is required to specify a range
with conditions
"In range" and "Out of range".
Remote command:
TRIGger<m>:RFFE:
MASK:CONDition on page 2067
TRIGger<m>:RFFE:MASK:MIN on page 2067
TRIGger<m>:RFFE:MASK:MAX on page 2067
13.17.3.2 Triggering on RFFE signals
Prerequisites: An RFFE bus is configured, see Chapter 13.17.2, "RFFE configuration",
on page 757, and "Decode"
is enabled.
1. Press the [Bus] key and selet the "Shortcuts" tab.
2. Press "Setup trigger".
3. Tap the "Source" button and select the "Serial bus" trigger source.
4. Tap "Serial bus" and select the serial bus that is set to RFFE.
5. Select the "Trigger type".
6. To refine the trigger settings, configure additional settings, which are available for
many trigger types.
For details, see Chapter 13.17.3.1, "RFFE trigger settings", on page 760.
13.17.4 RFFE label list
Label lists are protocol-specific. A label list file for RFFE contains slave addresses
and/or register addresses and their symbolic names:
●
"SA": slave address (SID in the labal list file)
●
Address: register address.
●
"Symbolic label": symbolic name as combination of the slave name (SID text) and
the address name (Address text), specifying the device function
RFFE (option R&S R
T
O6-K550)