Protocol analysis
R&S
®
RTO6
504User Manual 1801.6687.02 ─ 05
Remote command:
TRIGger<m>:
I2C:ACCess
on page 1679
TRIGger<m>:I2C:ADOR<n>:RWBit on page 1682
OR x
Enables each selected condition, for "Trigger Type" = "Address OR".
Remote command:
TRIGger<m>:I2C:ADOR<n>:ENABle on page 1681
Position
Sets the number of data bytes to be skipped after the address. You can define an exact
position, or a position range. The index 0 is associated with the first data byte.
"Condition"
Sets the comparison condition to a specific value or a range.
"Index min"
Specifies the value or sets the start value of a range.
" Index max"
Sets the maximum value of a range for "Condition" = "In range"/"Out
of range".
Remote command:
TRIGger<m>:I2C:DPOPerator
on page 1683
TRIGger<m>:I2C:DPOSition on page 1683
TRIGger<m>:I2C:DPTO on page 1683
Data
Specifies the trigger conditions for the data bit pattern.
In binary format, use the following characters: 1; 0; or X (do not care). To enter the pat-
tern in other formats use the bit pattern editor, see Chapter 13.1.7, "Bit pattern editor",
on page 493.
"Condition"
Sets the comparison condition to a specific value or a range.
"Value min "
Specifies the value or sets the start value of a range.
Enter the bytes in msb first bit order. The maximum pattern length is
64 bit. W
aveform data is compared with the pattern byte-by-byte.
"Value max "
Sets the maximum value of a range for "Condition" = "In range"/"Out
of range".
Remote command:
TRIGger<m>:
I2C:DCONdition
on page 1683
TRIGger<m>:I2C:DMIN on page 1684
TRIGger<m>:I2C:DMAX on page 1684
13.2.3.2 Triggering on I²C signals
Prerequisites: An I²C bus is configured, see Chapter 13.2.2.3, "Configuring I²C proto-
col", on page
499.
1.
Press the [Bus] key and select the "Shortcuts" tab.
2. Press "Setup trigger".
I²C (option R&S R
T
O6-K510)
To Next Page
Loading...
