Measurements
R&S
®
RTO6
359User Manual 1801.6687.02 ─ 05
2. Activate the measurement group.
3.
Select the "Result Analysis"
tab.
4. Enable the track.
See also: "Enable (Track)" on page 361.
8.2.12.5 Settings for result analysis
The settings in the "Result Analysis" tab activate and configure long-term measure-
ments, statistical calculations, and the histogram of measurement results over a longer
period of time.
For scaling settings of the long-term diagram, see Chapter 8.2.12.6, "Horizontal long-
term scaling", on page 362.
Measurement for plot
Selects the measurement that is used as source for mathematic calculations, long-term
measurements, and histograms. These evaluations are performed on one measure-
ment only, not on all measurements of the group. Statistics are calculated for all mea-
surements.
The selected measurement cannot be disabled in the
"Add / Remove Measurement"
dialog box.
Automatic measurements
To Next Page
Loading...
