Remote control commands
R&S
®
RTO6
1354User Manual 1801.6687.02 ─ 05
*RST: AUTO
Usage: Asynchronous command
PROBe<m>:SETup:ADVanced:FILTer <BwFilterSt>
Enables the lowpass filter in the probe control box.
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<BwFilterSt> ON | OFF
*RST: OFF
Usage: Asynchronous command
PROBe<m>:SETup:ADVanced:AUDioverload <Sound>
Activates the acustic overrange warning in the probe control box.
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<Sound> ON | OFF
*RST: OFF
Usage: Asynchronous command
24.8.7.5 Modular probes
The commands of this chapter are relevant for R&S RT‑ZM modular probes. The com-
mands are available in firmware version 3.40 and higher.
The suffix <m> selects the input channel to which the probe is connected.
PROBe<m>:SETup:PRMode.........................................................................................1354
PROBe<m>:SETup:DMOFfset...................................................................................... 1355
PROBe<m>:SETup:CMOFfset...................................................................................... 1355
PROBe<m>:SETup:NOFFset........................................................................................ 1356
PROBe<m>:SETup:POFFset........................................................................................ 1356
PROBe<m>:SETup:TERM:STATe..................................................................................1356
PROBe<m>:SETup:TERM:MODE................................................................................. 1357
PROBe<m>:SETup:TERM:MEASure?........................................................................... 1357
PROBe<m>:SETup:TERM:ADJust.................................................................................1357
PROBe<m>:SETup:PRMode <MeasMode>
Sets the measurement mode of the modular probe.
Acquisition and setup
To Next Page
Loading...
