R&S RTO6 - 24.8.14 Reference clock; 24.9 Trigger

Remote control commands
R&S
®
RTO6
1388User Manual 1801.6687.02 ─ 05
Usage: Asynchronous command
24.8.14 Reference clock
Commands are related to the external reference input on the rear panel, and the output
of the OCXO reference signal.
SENSe[:ROSCillator]:SOURce......................................................................................
1388
SENSe[:ROSCillator]:EXT
ernal:FREQuency................................................................... 1388
SENSe[:ROSCillator]:SOURce <RefSource>
Enables the use of the external reference signal instead of the internal OCXO refer-
ence.
Parameters:
<RefSource> INTernal | EXTernal
*RST: INTernal
Usage: Asynchronous command
SENSe[:ROSCillator]:EXTernal:FREQuency <ExternalRef>
Sets the frequency of an external reference input signal that is connected to the exter-
nal reference input on the rear panel.
Parameters:
<ExternalRef> *RST: 10E+6
Default unit: Hz
Usage: Asynchronous command
24.9 T
rigger
Some of the commands in the following chapter are asynchronous. An overlapping or
asynchronous command does not automatically finish executing before the next com-
mand starts executing. If overlapping commands must be executed in a defined order,
e.g. to avoid wrong measurement results, they must be serviced sequentially.
T
o prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
●
Chapter 24.3, "Programming examples", on page 1259
● Basic trigger settings...........................................................................................1389
● Edge trigger.........................................................................................................1392
● Glitch trigger........................................................................................................1393
Trigger