Compliance tests
R&S
®
RTO6
1221User Manual 1801.6687.02 ─ 05
21.4.1 T
est equipment
For eMMC compliance tests, the following test equipment is needed:
●
R&S
RTO6 oscilloscope with at least 1 GHz bandwidth
●
A probe with at least 1.5 GHz bandwidth
●
R&S RTO6-K92 eMMC compliance test option (required option, installed on the
R&S RTO6)
●
The free-of-charge R&S ScopeSuite software, which can be installed on a com-
puter or directly on the R&S RTO6.
21.5 PCIe compliance tests (option R&S RTO6-K81)
The option R&S RTO6-K81 enables the automatic processing of PCIe 1.1 / PCIe 2.0
compliance tests.
The PCIe compliance test procedures are described in a separate manual:
●
R&S®RTO-K81, R&S®RTP-K81/-K83, PCIe Compliance Test, User Manual"
21.5.1 Test equipment
PCIe 1.1 / PCIe 2.0 Test Equipment
For PCIe compliance tests, the following test equipment is needed:
●
R&S RTO6 oscilloscope with at least 6 GHz bandwidth, 2 channels and 20 GS/s
available
●
Probes/cables:
– Two SMP to SMA cables or
– Two single-ended probes with at least 6GHz bandwidth bandwidth or
– One differential probe with at least 6GHz bandwidth bandwidth
●
R&S RTO6-K81 PCIe compliance test option (required option, installed on the
oscilloscope)
●
Recommended test fixture:
– For Add-In card testing: PCI Express Compliance Base Board (CBB2.0) from
PCI-SIG
– For System Board testing: PCI Express Compliance Load Board (CLB2.0) from
PCI-SIG
●
The free-of-charge R&S ScopeSuite software, which can be installed on a com-
puter or directly on the oscilloscope.
PCIe compliance tests (option R&S RTO6-K81)
To Next Page
Loading...
