Search functions
R&S
®
RTO6
435User Manual 1801.6687.02 ─ 05
3. Enter a name for the search using the on-screen keyboard.
To configure a user-defined search
1.
Open the search dialog: "Menu" > "Apps" > "Analysis" tab > "Search".
2. Select the "Setup" tab and the search that you want to configure.
3. Select the "Source" on which you want to perform the search.
4. Select the events that you want to include in the search.
5. Define the settings of the first search event.
To use the same conditions as defined in the trigger configuration of the A-event,
tap "Copy from trigger A'". The selected trigger settings are applied to the search
settings.
6. Repeat the previous steps to define further events for the same search.
7. To perform the search only on a part of the waveform, configure the gate in the
"Gate" tab as described in Chapter 11.3.2, "Defining the search gate",
on page 437.
11.3 Search gate
The gate defines the search area within the source waveform. You can use absolute or
relative values to define the gate, or couple it to a previously defined zoom area.
11.3.1
Gate settings
Access: "Menu" > "Apps" > "Analysis" tab > "Search" > "Gate" tab
The search gate settings are identical to those for gate areas for measurements or FFT
analysis.
Gating is not available if the search source is a digital channel or a serial bus.
Search gate
To Next Page
Loading...
