Protocol analysis
R&S
®
RTO6
963User Manual 1801.6687.02 ─ 05
Remote Commands:
●
SEARch:RESult:
PCIE:
PCOunt? on page 2386
●
SEARch:RESult:PCIE:PACKet<m>:ADDR? on page 2381
●
SEARch:RESult:PCIE:PACKet<m>:CPID? on page 2381
●
SEARch:RESult:PCIE:PACKet<m>:CPS? on page 2381
●
SEARch:RESult:PCIE:PACKet<m>:DATA? on page 2381
●
SEARch:RESult:PCIE:PACKet<m>:DFC? on page 2382
●
SEARch:RESult:PCIE:PACKet<m>:FCOunt? on page 2382
●
SEARch:RESult:PCIE:PACKet<m>:HFC? on page 2383
●
SEARch:RESult:PCIE:PACKet<m>:LEN? on page 2384
●
SEARch:RESult:PCIE:PACKet<m>:RQID? on page 2384
●
SEARch:RESult:PCIE:PACKet<m>:SEQN? on page 2384
●
SEARch:RESult:PCIE:PACKet<m>:STARt? on page 2385
●
SEARch:RESult:PCIE:PACKet<m>:STATe? on page 2385
●
SEARch:RESult:PCIE:PACKet<m>:STOP? on page 2385
●
SEARch:RESult:PCIE:PACKet<m>:TAG? on page 2385
●
SEARch:RESult:PCIE:PACKet<m>:TYPE? on page 2386
●
SEARch:RESult:PCIE:PACKet<m>:FCOunt? on page 2382
●
SEARch:RESult:PCIE:PACKet<m>:FLD<n>:FVAL? on page 2382
●
SEARch:RESult:PCIE:PACKet<m>:FLD<n>:STATus? on page 2382
●
SEARch:RESult:PCIE:PACKet<m>:FLD<n>:TYPE? on page 2383
●
SEARch:RESult:PCIE:PACKet<m>:FLD<n>:VAL? on page 2383
13.26.6.3 Searching for PCIe Gen 1/2
Prerequisite: A serial bus is configured for the PCIe signal to be decoded and ana-
lyzed.
The search for events is set up in the following way:
1.
Press the [Bus] key and selet the "Shortcuts" tab.
2. Tap "Setup search".
3. If the dialog box does not contain a search entry, tap the "Add" icon to create one,
as described in "To create a user-defined search" on page 434.
4. Tap "Source" and select the serial bus that is set to PCIe (e.g. "SB1").
5. Specify the search criteria according to Chapter 13.26.6.1, "PCIe Gen 1/2 search
settings", on page 953.
6. To acquire a waveform, press [Single].
The R&S RTO6 performs an PCIe decode according to the thresholds and protocol
settings of the associated serial bus source.
PCIe (option R&S R
T
O6-K72)
To Next Page
Loading...
