Getting started
R&S
®
RTO6
53User Manual 1801.6687.02 ─ 05
4. To define the analyzed area, do one of the following:
● T
ap the required diagram.
● Drag a rectangle on the diagram.
3.3.6.2 Configuring the toolbar
You can configure the content of the toolbar so that only the required functions are dis-
played. The toolbar configuration is part of the user preferences. It is retained when
you switch off and on the instrument, and you can save it in the user preferences and
user-defined preset.
1. To open the toolbar configuration, tap the icon in the toolbar:
2. Select the required toolbar functions:
● Disable the functions that you do not need.
●
Enable the functions that you want to add to the toolbar.
3. Close the dialog.
A detailed description of the toolbar functions is given in Chapter 3.3.6.3, "Toolbar func-
tions", on page 53.
3.3.6.3 Toolbar functions
This section describes all toolbar functions in detail.
Operating the instrument
To Next Page
Loading...
