R&S RTO6 - 13.21.5 Search on decoded USB 3.1 data; 13.21.5.1 USB 3.1 search setup

Protocol analysis
R&S
®
RTO6
858User Manual 1801.6687.02 ─ 05
Column Description
Numeric value The numeric value of the field
Formatted Formatted content of the field, for example HPSTART "F7" = end packet framing
(EPF)
Remote commands
Remote control commands for retrieving decode results are described in Chap-
ter 24.17.22, "USB 3.1 (option R&S RT
O6-K570)", on page 2188.
Remote command:
●
BUS<m>:USBThree:RESult:FCOunt? on page 2204
●
BUS<m>:USBThree:RESult:FRAMe<n>:INFO? on page 2204
●
BUS<m>:USBThree:RESult:FRAMe<n>:TYPE? on page 2204
●
BUS<m>:USBThree:RESult:FRAMe<n>:STATe? on page 2205
●
BUS<m>:USBThree:RESult:FRAMe<n>:STARt? on page 2205
●
BUS<m>:USBThree:RESult:FRAMe<n>:STOP? on page 2206
●
BUS<m>:USBThree:RESult:FRAMe<n>:FLD<o>:TYPE? on page 2206
●
BUS<m>:USBThree:RESult:FRAMe<n>:FLD<o>:STATus? on page 2206
●
BUS<m>:USBThree:RESult:FRAMe<n>:FLD<o>:STARt? on page 2207
●
BUS<m>:USBThree:RESult:FRAMe<n>:FLD<o>:STOP? on page 2207
●
BUS<m>:USBThree:RESult:FRAMe<n>:FLD<o>:VAL? on page 2207
●
BUS<m>:USBThree:RESult:FRAMe<n>:FLD<o>:FVAL? on page 2208
13.21.5 Search on decoded USB 3.1 data
Using the search functionality, you can find various events in the decoded data. You
can find the same events that you can trigger on, and even many more, since several
event types can also be combined.
Before you can start the search, you have to configure the bus correctly and acquire
decoded data.
To search on decoded data, set the search source to "SerBus" for the configured proto-
col.
For general information on how to handle the search functionality, see Chapter 11,
"Search functions", on page 419.
If you need information on how to get started with searching USB 3.1 data, see Chap-
ter 13.21.5.3, "Searching USB 3.1 data", on page 860. Otherwise proceed with the
USB 3.1 search setup.
13.21.5.1 USB 3.1 search setup
Access: [Bus] > "Shortcuts" tab > "Setup search"
USB 3.1 (option R&S R
T
O6-K570)