R&S RTO6 - 13.11.2.3 Display settings; 13.11.2.4 Configuring the CXPI signals

Protocol analysis
R&S
®
RTO6
670User Manual 1801.6687.02 ─ 05
Display order
Selects the order in which the signal is displayed in the honeycomb.
"As transmitted"
The signal is displayed in the order it occurs.
"Logical"
The signal is displayed according to the definition of the standard
(MSB bit order).
Remote command:
BUS<m>:
CXPI:DORD on page
1931
Enable bit rate/ Average bit rate
If enabled, sets the number of transmitted bits per second. If disabled, the bit rate is
measured and the average bit rate in the acquisition window is displayed.
Remote command:
BUS<m>:CXPI:BITRate:ENABle on page 1930
BUS<m>:CXPI:BITRate:VALue on page 1930
BUS<m>:CXPI:RESult:BITRate? on page 1930
13.11.2.3 Display settings
Access: [Bus] > "Display" tab.
For common display settings, see Chapter 13.1.3, "Display", on page 487.
13.1
1.2.4 Configuring the CXPI signals
For configuration, assign the lines to the input channels and define the logical thresh-
olds and the hysteresis.
1. Press the [Bus]
key on the front panel.
2. Select the tab of the bus you want to set up, for example "SB1".
3. Select the "Setup" tab.
4. Tap the "Protocol" button and select the protocol: "CXPI".
5. Tap the "Variant" button, and select the protocol.
6. Select the source and the polarity.
CXPI (option R&S RT
O6-K520)