R&S RTO6 - 11.2.2.4 Runt

Search functions
R&S
®
RTO6
425User Manual 1801.6687.02 ─ 05
Polarity, Range, Width, ±Delta
See trigger settings:
●
"Polarity" on page 198
While the width trigger can only analyze positive or
negative polarity, searching for
a width is also possible for both polarities at the same time ("Either").
●
"Range" on page 199
●
"Width" on page 199
●
"±Delta" on page 199
Remote command:
SEARch:TRIGger:WIDTh:POLarity on page 1617
SEARch:TRIGger:WIDTh:RANGe on page 1618
SEARch:TRIGger:WIDTh:WIDTh on page 1618
SEARch:TRIGger:WIDTh:DELTa on page 1617
Level
Sets the voltage level for trigger search. The value is used for all search event types
that require one trigger level. The search trigger level is search-specific, you can define
different levels in dif
ferent searches for the same event.
Remote command:
SEARch:TRIGger:LEVel[:VALue] on page 1607
11.2.2.4 Runt
The runt search settings are the same as the runt trigger settings. To apply the trigger
settings to search, tap Copy from trigger A'.
The runt search is not available, if the search source is a digital channel.
Search setup